Space Navigator support

Question

I have a 3Dconnexion Space Navigator
see:
http://www.3dconnexion.com/products/spacenavigator.html
I have no programming skills, but I have used this with AutoCAD and it is very useful.
Any thoughts being entertained to allow this to be used with progeCAD?
Thanks
paul

Answer 1

ProgeCAD is using the windows system driver to drive the mouse so if your space modulator will run on Windows, and has a prototype settings for AutoCAD it should not be overly difficult to set it up for progeCAD. You will just have to test the AutoCAD commands and make any changes to the settings for buttons where progeCAD differs in it's command names and/or command options.

Thank you,

Scott:


Space Navigator support

I have a 3Dconnexion Space Navigator
see:
http://www.3dconnexion.com/products/spacenavigator.html
I have no programming skills, but I have used this with AutoCAD and it is very useful.
Any thoughts being entertained to allow this to be used with progeCAD?
Thanks
paul