I get a error msg “Converter is not properly installed please reinstall” Should I and how do I do that?

When progeCAD first loads I get this error message “Converter is not properly installed please reinstall” Should I reinstall the “converter” and how do I do that? I have the progeCAD 2007 and I just started to get the message about 6 months ago. To me it is more of a nuisance than a big problem because everything seams to work OK so I have not

asked 10 months ago in progeCAD by Bob at Jacar / Level: Smart End of the Tape Measure (4 points)

1 Answer

0 like 0 dislike

Without uninstalling, go ahead and re-install progeCAD over the top of what you have and this may alleviate your error.

answered 10 months ago by Scott H / Level: Engineering Manager (3,105 points)

Please log in or register to answer this question.

Related questions

3 answers

> I tried remove the printer and reinstall few times and get the same error message code :2 as the following:

asked 10 months ago in progeCAD by ThuVu / Level: CAD Student (48 points)

1 answer

I get a "Warning (CF-0x07) A General Error Occurs" and ProgeCAd 2013 does not start.

asked 4 months ago in progeCAD by Bob at Jacar / Level: Smart End of the Tape Measure (4 points)

2 answers

What flash plugin is required for 3D Video Training -- error message that says "Please install flash plugin"

asked 1 year ago in progeCAD by jfeeney / Level: Smart End of the Tape Measure (2 points)

1 answer

Why do I get a Automation error when trying to modify and attribute in Block attribute manager?

asked 5 months ago in progeCAD by alanrkeen / Level: Smart End of the Tape Measure (2 points)