Digital Terrain Modeling

Digital Terrain Modeling  is an add-on program for progeCAD®.
You will need progeCAD® to run this program.

Create a TIN

Create a Triangular Irregular Network of a set of points. Any point file in the xyz format can be used to create a surface model. Fault lines may be added to the model to control the triangulation process. Boundaries and voids may also be used to control the appearance of the model.

Contours

Contours may be created at user defined intervals and placed on user defined layers.

Mesh Creation

A mesh may be created of the surface.

Calculate Cut and Fill

Volume calculations may be made between two surfaces.

Unlimited Surfaces

Create an unlimited number of surfaces.

DTM Profile Cutter

Select a polyline alignment and cut a profile from the surface. The profile may then be imported into a drawing. The program places a grid around the profile and annotates stations and existing ground elevations on a user defined interval. You may overlay the existing profile with a new profile cut from a modified surface model.