Home  >  Support  >  progeCAD Questions
become a progeCAD superstar, earn points giving your friends CAD answers!

progeCad 2014 when I view - zoom - extents the drawing goes everywhere but center.

When I use the -View-zoom-extents cmd. The drawing sometimes goes left, then sometimes right.
It should center as it does(still does)in v2013. In any case it should go to the same place at least.
Please note there is nothing outside my drawing boundary that would cause this. I tried several drawings had same results. They all worked in progeCad 2013 Pro.
asked 2 years ago in progeCAD by BillyV / Level: Smart End of the Tape Measure (6 points)

1 Answer

0 like 0 dislike
Dear progeCAD Customer,

we'd like to be able to correctly investigate your report.
Please forward a sample copy of a mentioned drawing, that you were not able to zoom as expected, and the complete list of steps to follow, to directly analyze the obtained result.

Please forward the required information/data to the following email address: support@progeCAD.com

We look forward to receiving them, we will be able to better assist you thereafter. Thank you,

Best regards
answered 2 years ago by progeCAD / Level: Engineering Manager (3,668 points)

Please log in or register to answer this question.

Related questions